The options may be changed whilst the CPU Switch Smart SUN-MAC-PC is in configure mode. You may enter configure mode at initial power on or whilst the CPU Switch Smart SUN-MAC-PC is running:
To enter configure mode at power on:
Switch off all the attached computers and the CPU Switch Smart SUN-MAC-PC. Hold down the front panel key whilst powering on the CPU Switch Smart SUN-MAC- PC. Remember that the CPU Switch Smart SUN-MAC-PC draws its power from any attached PC via the keyboard cable and so will power itself on when the attached PC is switched on or when the optional power adapter is connected. Do not release the key until the CPU Switch Smart SUN-MAC-PC displays 'u'. Whilst the CPU Switch Smart is displaying 'u', press and hold down the front panel key for 5 seconds until the CPU Switch Smart SUN-MAC-PC displays 'C' to show that it has entered configure mode.
If you wish you may use the reset switch that is situated on the underside of the CPU Switch Smart SUN-MAC-PC (see figure 4) to perform a power-on reset without powering down the connected computers.
To enter configure mode whilst the CPU Switch Smart SUN-MAC-PC is running:
Hold down the front panel key for 5 seconds until the front panel display shows ‘C’.
In configure mode, options are entered by typing a letter followed by a number followed by (return). Use ESC to abort the entry of an option. The CPU Switch Smart SUN-MAC-PC will remain in configure mode until you type 'E' (return).
For example: to set hotkey option 2 type the following at the 'C' prompt
(at CPU Switch Smart SUN-MAC-PC 'C' prompt) | H2f |
To exit configure mode type:
CPU Switch Smart SUN-MAC-PCInstallation and Use | Page 17 |
