Manuals / Linear / Baby / Safety Gate

Linear SLD, SLR, SLC manual Safety Edge Layout Illustration #2

Models: SLD SLR SLC

1 36

Download 36 pages 21.87 Kb

Page 21

SLR • SLC • SLD Slide Gate Operator Installation Guide

- 19 -

THIS DRAWING IS INTENDED TO DRAW ATTENTION TO POSSIBLE LOCATIONS FOR THE INSTALLATION OF CONTACT OR NON-CONTACT OBSTRUCTION SENSING DEVICES. OTHER AREAS OF ENTRAPMENT MAY EXIST DEPENDING ON EACH SPECIFIC INSTALLATION.

SEE NOTE

ITEM #2

SEE NOTE

ITEM #1

JUNCTION BOX MOUNTED

COILED CORD SHOULD EXTENDTO FENCE POST EQUALLY DURING OPEN AND CLOSE

SEE NOTE

ITEM #4

SEE NOTE

ITEM #1

Safety Edge Layout Illustration #2

227968 Revision X13 2-3-09

SEE NOTE ITEM #3

SEE NOTE

ITEM #2

SEE NOTE

ITEM #1

SLIDE GATE OPERATOR WIRED DIRECT TO EDGE

USING JUNCTION BOX AND COIL CORD

NOTES:

1.WIRE THESE EDGES FOR CLOSE OBSTRUCTION

2.WIRE THESE EDGES FOR OPEN OBSTRUCTION

3.ON LEADING EDGE, WIRE FOR CLOSING OBSTRUCTION OR REVERSING IF DESIRED

4.ON TRAILING EDGE, WIRE FOR OPEN OBSTRUCTION

REFER TO ACCESSORY CONNECTIONS PAGES FOR DETAILS

5.IF SENSOR EDGES ARE HARD WIRED TO THE OPERATOR, CARE MUST BE TAKEN IN ROUTING THE WIRES SUCH THAT THEY DO NOT BECOME DAMAGED DURING NORMAL OPERATION (AVOID PINCHING AND ABRASION)

Image 21

Linear SLD, SLR, SLC manual Safety Edge Layout Illustration #2

Contents

SLR SLC SLD Table of Contents Always Check the Gate’s Action Before You BeginRegulatory Warnings Gate Operator ClassificationsWiring Specifications AC Power WiringDC Control and Accessory Wiring Mounting Pad Specifications Mounting Pad InstallationGate Preparation Gate PostEND of Gate Pipe Shown Reference only Gate Bracket and Chain AssemblyOperator Preparation Operator SetupLimit Nuts Rough Adjustment Limit Nuts Fine AdjustmentRIGHT-HAND Installation Connectors Controller FeaturesBlinks if Connection has Failed Maint Alert SET Indicator DescriptionsTerminal Group Function Terminal DescriptionsOperator Accessory Connections Operator Accessory ConnectionsBasic Controller Programming Run Alarm and Pre-start Alarm Maximum Open Direction Current SettingMaximum Close Direction Current Setting Single Button Input Setup Entering Advanced Programming ModeAdvanced Controller Programming Maximum Run TimeReverse Delay Time Auxiliary Relay ModeLow Power Mode Power Failure ModeMaintenance Alert Trigger Reset Cycle CountSoft Start/Stop Duration Mid-travel Stop PositionAntenna Installation Radio EnableReset Controller to Factory Defaults Radio Transmitter LearnLoop Sealant Loop Layout IllustrationUSE Relief Cuts AT Corners SLR SLC SLD Safety Edge Layout Illustration Safety Edge Layout Illustration #2 Photoeye Installation Illustration Pickets Space Smaller than 2 1/4 Entrapment Zone #3Entrapment Zone #1 Gate Bracket Bolted to Channel Track Gate InstallationOpen and Close Limit settings Dual Gate InstallationsOperator #1 ShieldOperation Indications Gate OperationEntrapment Error IndicationsComm Link Connection Failure MGT Obstacle Transmitter TroubleTroubleshooting Optional Parts Model SLR Exploded ViewOptional Torque Limiter Model SLC Exploded ViewCapacitors For drives 34 to 47 feet wideLimiter Model SLD Exploded ViewModel SLD Mechanical Parts List Battery Maintenance Model SLD MaintenanceDC Motor Brush Replacement When NEWMonth Preventative Maintenance Preventative MaintenanceFCC Notice GeneralInstaller Customer Gate Operator Installation Checklist