Linksys SRW208G, SRW208MP, SRW208L, SRW208P manual Wall-Mount Placement

Chapter 3 Installation

Print this page at 100% size, cut along the dotted line and place on the wall to drill precise spacing.

Wall-Mount Placement

When mounting the Switch on the wall, the Switch should be mounted horizontally. The front panel should face either up or down. The unit should not be positioned vertically when mounted. You will need two suitable screws to mount the Switch. Use the template above to plan your installation.

Proper Wall-Mount Orientation (Horizontal)

NOTE: Linksys is not responsible for damages incurred by insecure wall-mounting hardware.

1.Determine where you want to mount the Switch. Ensure that the wall you use is smooth, flat, dry and

sturdy and make sure the location is within reach of the power outlet.

2.Drill two holes into the wall. Make sure the holes are 3.7 inches (94 mm) apart. You can print the template from this page.

3.Insert a screw into each hole, and leave 3 mm (0.12 in) of its head exposed.

4.Maneuver the Switch so the wall-mount slots line up with the two screws.

5.Place the wall-mount slots over the screws and slide the Switch down until the screws fit snugly into the wall-mount slots.

Incorrect Wall-Mount Orientation (Vertical)

Congratulations! The wall-mount installation of the Switch is complete.

8-Port 10/100 Ethernet Switch with Webview 7