Wireless-G Access Point with Power Over Ethernet and Rangebooster

The Ports

The Access Point’s port are located on the back of the device.

Figure 3-2: Back View

Reset Button

There are two ways to reset the Access Point to the factory default configuration. Either press

 

the Reset button, for approximately ten seconds, or restore the defaults using the Access

 

Point's web-based utility.

Ethernet

The Ethernet network port connects to Ethernet network devices, such as a switch or router

 

that may or may not support Power over Ethernet (PoE).

Power

The Power port connects to the supplied power adapter.

Chapter 3: Getting to Know the Wireless-G Access Point

port: the connection point on a computer or networking device used for plugging in cables or adapters

IMPORTANT: Resetting the Access Point will erase all of your settings (including wireless security, IP address, and SSID) and replace them with the factory defaults. Do not reset the Access Point if you want to retain these settings.

8

The Ports

Page 14
Image 14
Linksys WAP200RF manual Ports, Access Point’s port are located on the back of the device