Placement Options, Stand Option | Linksys WAP200RF specification

Wireless-G Access Point with Power Over Ethernet and Rangebooster

Placement Options

There are three ways to place the Wireless-G Access Point. The first way is to place it horizontally on a surface, so it sits on its four rubber feet. The second way is to stand the Access Point vertically on a surface. The third way is to mount it on a wall. The stand and wall-mount options are explained in further detail below.

Stand Option

1.Locate the Access Point’s left side panel.

2.The Access Point includes two stands. With the two large prongs facing outward, insert the short prongs into the little slots in the Access Point, and push the stand upward until it snaps into place.

Repeat this step with the other stand.

Now that the hardware installation is complete, proceed to “Chapter 5: Setting up the Wireless-G Access

Point,” for directions on how to set up the Access Point.

Large

Prongs

Figure 4-3: Stand

Wall-Mount Option

1.On the Access Point’s back panel are two crisscross wall-mount slots.

2.Determine where you want to mount the Access Point, and install two screws that are 2-15/16" apart.

3.Line up the Access Point so that the wall-mount slots line up with the two screws.

4.Place the wall-mount slots over the screws and slide the Access Point down until the screws fit snugly into the wall-mount slots.

Now that the hardware installation is complete, proceed to “Chapter 5: Setting up the Wireless-G Access

Point,” for directions on how to set up the Access Point.

Chapter 4: Connecting the Wireless-G Access Point

2-15/16"

Figure 4-4: Mounting Dimensions

11

Placement Options

Image 17

Linksys WAP200RF manual Placement Options, Stand Option, Wall-Mount Option

Contents

User Guide Copyright and Trademarks How to Use this User Guide Table of Contents Frequently Asked Questions Appendix a TroubleshootingAppendix B Wireless Security List of Figures Example of a Simple Wireless Network 20 Security Monitor Basic Settings Welcome Introduction What’s in this User Guide? Introduction What’s in this User Guide? Roaming Planning Your Wireless NetworkNetwork Topology Network Layout Example of a simple wireless network LEDs Getting to Know the Wireless-G Access Point Ports Access Point’s port are located on the back of the device Antennas and Positions Desktop Placement and Antenna Setup Connection Connecting the Wireless-G Access PointOverview Wall-Mount Option Placement OptionsStand Option Accessing the Utility Setting Up the Wireless-G Access Point Navigating the Utility SetupWireless Security Monitor AP ModeAdministration Status Setup Basic Setup Tab Configuring the Wireless-G Access PointBasic Setup Network Setup Time Setup Time Tab Basic Settings Wireless Basic Wireless Settings Tab Wireless Security Wireless Wireless Security Tab WPA2-Personal WPA-Personal aka WPA-PSK WPA-Enterprise WPA2-Personal Mixed WPA2-Enterprise Mixed WPA2-Enterprise Radius Disable Wireless Connection Control Wireless Wireless Connection Control TabWireless Client List Connection Control Advanced Settings Wireless Advanced Wireless Settings Tab Vlan Wireless Vlan & QoS Tab QoS MAC Address AP Mode Tab 18 Wireless Repeater Mode 19 Wireless Bridge Mode Security Monitor Accounts Security Monitor Basic Settings TabWireless Security Monitor Mail Notification Security Monitor Event Log Tab Syslog Notification Web Access Administration Management TabLocal AP Password Management Identification Snmp Log Administration Log TabEmail Alert Notification Queue Length Administration Firmware Upgrade Tab Administration Factory Default TabFactory Default Firmware Upgrade Administration Config Management Tab Administration Reboot TabReboot Config Management Local Network Status Local Network TabInformation Wireless Network Status Wireless Tab Wireless WiredStatus System Performance Tab System PerformancePage Frequently Asked Questions Appendix a Troubleshooting What Ieee 802.11g features are supported? What is the ISM band? Does the Access Point function as a firewall? Security Threats Facing Wireless Networks Appendix B Wireless SecuritySecurity Precautions Appendix B Wireless Security Page Appendix C Upgrading Firmware Network Neighborhood/My Network Places Appendix D Windows HelpShared Resources Appendix E Glossary Appendix E Glossary Appendix E Glossary Appendix E Glossary Appendix E Glossary 802.11F Wireless Roaming Appendix F Specifications 11g 14 dBm Dhcp Client11.g 54Mbps@ -72dBm, 11.b 11Mbps@ -85dBM Security Certification Wireless Security MonitorSuspicious network events Limited Warranty Appendix G Warranty Information Appendix H Regulatory Information Appendix H Regulatory Information Appendix H Regulatory Information Appendix H Regulatory Information Appendix H Regulatory Information Appendix H Regulatory Information Appendix H Regulatory Information Information section in this Guide Appendix I Contact InformationNeed to contact Linksys?