Wireless-G Business USB Network Adapter with RangeBooster
To edit the new settings, click the Back button. To exit the Manual Setup through the Wireless Network
Monitor, click Exit.
4.After the software has been successfully installed, the Congratulations screen will appear. Click Connect to Network to connect to your network and return to the Link Information screen.
Click Return to Profile Screen to keep the current settings active and return to the Profiles screen.
For more information about the Wireless Network Monitor, refer to Chapter 5: Using the Wireless Network Monitor.
Congratulations! The installation of the |
| |
To check the link information, search for available wireless networks, or make additional configuration | Figure | |
changes, proceed to Chapter 5: Using the Wireless Network Monitor. | ||
|
Manual Setup
If your network is not listed with the available networks, you can use Manual Setup.
1.Click Manual Setup on the Available Wireless Network screen to set up the adapter manually.
2.The Network Settings screen from the Wireless Network Monitor will appear. If your network has a router or other DHCP server, click the radio button next to Obtain network settings automatically (DHCP).
If your network does not have a DHCP server, click the radio button next to Specify network settings. Enter an IP Address, Subnet Mask, Default Gateway, and DNS addresses appropriate for your network. You must specify the IP Address and Subnet Mask on this screen. If you are unsure about the Default Gateway and DNS addresses, leave these fields empty.
IP Address - This IP Address must be unique to your network.
Subnet Mask - The Adapter’s Subnet Mask must be the same as your wired network’s Subnet Mask.
Chapter 4: Setting up and Connecting the
Figure 4-11: Network Settings - Wireless Mode
12
Setting up the Adapter
