System Setup Controls
ENG
RS-485 SUBMENU
The information in the
PAN/TILT DEVICE SUBMENU
NOTE: The configuration settings for this section would be provided with the documentation included with the PTZ Camera.
•CHANNEL: Select the Channel where PTZ camera is connected.
•ID: Assign the specific ID of the PTZ camera.
•MODEL: Select the model of PTZ camera.
•PAN/TILT TEST: Test PTZ Camera.
NOTE: The configuration settings for this section would be provided with the documentation included with the
•BAUDRATE: Set the Data Transmission (Baud rate) to1200, 1800, 2400, 4800, 9600, 14400, 19200, 36400, 57600 or 115200 bps.
•DATA BIT: Set the Data Transmission Bit to 7 or 8.
•PARITY BIT: Set the Data Transmission Error Check Bit to odd, even or none.
•STOP BIT: Set the Data Transmission Stop Bit to 1 or 2.
PAN/TILT DEVICE SUBMENU
The information in the PAN/TILT Device submenu allows users to configure the settings for a PTZ Camera.
F/W UPGRADE
The DVR supports upgrading the Firmware through a USB Memory Stick.
If a USB Memory Stick is not detected by the system, a failure message will appear:
If a USB Memory Stick is detected with valid Firmware files, the following screen will appear:
Press the PLAY Button to update the firmware, or press the STOP Button to cancel.
33
