Appendix #7 – Connecting Motion / Alarm Device
Appendix #7 – Connecting Motion / Alarm Device
Motion detection and Alarm controls are enabled through the Menu system on the DVR. Additional motion sensor devices can be connected to the system (Motion Sensors, Door/Window Sensors).
A motion detection or sensor unit can be used to send a signal to the DVR to begin camera viewing and recording on the matching Video Channel (when enabled in the Menu)
•Example: A Window sensor unit has been installed on Alarm Block port #4. When this sensor is activated, the camera on CH4 will become active (if enabled in the MENU on the DVR)
Installing a Sensor
1.Connect the GROUND Cable to the desired Channel number - port on the DVR.
2.Connect the SIGNAL Cable to the desired Channel number + port on the DVR.
DVR
SENSOR
(Not Included)
ALM OUT: Sends a signal to | PTZ RS485: Controls for | |
receive a signal from a device (i.e. | another device when an alarm | PTZ. See Appendix #7. |
Door or Window Sensor). | input is detected. |
|
73
ENG