System Setup Controls
ENG
RECORD SCHEDULE
Move cursor to the desired time using the ▲▼◄► arrows, and press the ENTER Button to scroll through the available recording settings:
•No Record – The System will not record video during this period.
•Time Record – The System will record data continuously during this period.
•Motion Record – The System will record data only when the camera recognizes motion in a designated area during this period.
•Sensor Record – The System will record data only when an sensor or alarm is signaled during this period.
•Motion + Sensor Record – The System will record data when either Motion or a Sensor/Alarm is detected.
•Time + Motion Record – The System will continuously record data during this period. If motion is detected during this time, the video will be flagged in the system as a Motion Event.
•To set the entire line (all hours in a day) to the same recording type, set one square in the day to the desired recording type. Remain on that square, and press the Record • Button.
•To set all days to the same recording type, use the mouse to set the top left corner (Sun 0hr) to the desired recording type, and click on the red diagonal arrow (to the upper left of the square).
RECORD SCHEDULE ENABLE
Sets the Recording Schedule to ON or OFF.
NOTE: It is important to leave this setting to ON. If this setting is turned OFF, the DVR will NOT record any data (Manual Recording (when the REC Button is pressed) will override the Record Settings, and immediately begin recording.)
SENSOR SETUP
ALARM DURATION
Determines how long an alarm lasts after detection. Settings include: OFF, 05, 10, 15, 20, 25, 30 Seconds or CONT (continuously).
If there are no sensors connected to the DVR, set the Alarm Duration to OFF.
SENSOR - 1, 2, 3, 4
Set the type of sensor installed for CH1~CH4. The settings include: DISABLE (none), Normally Open (NO) or Normally Closed (NC).
25
