Figure 2.4 SAS Plugs and SATA II Plugs and SAS Backplane Receptacle Connector

SAS Primary

Physical Link

Power

SAS Secondary

Physical Link

Power

SATA II

Physical Link

Serial Attached SCSI

SAS Backplane

Receptacle Connector

Power

Serial ATA

SAS Secondary

Physical Link

SATA II/SAS

Primary

Physical Link

Note: SATA II backplane connectors do not accept SAS drives.

The following subsections provide step-by-step instructions for connecting the SAS RAID controllers to SAS drives and SATA II drives, either directly or through an expander.

2.5.1Connecting a SAS RAID Controller with Internal Connectors to Drives

This section provides step-by-step instructions for connecting the SAS cable from the internal connectors on the RAID controller to SAS drives and SATA II drives.

Follow these steps to connect your RAID controller with internal SAS port connectors directly to SAS drives, SATA II drives, or both.

Note: The SAS 9260-8i RAID controller is shown as an example. You can connect other SAS controllers with internal SAS port connectors in the same way.

Step 1. Insert the SFF-8087 x4 internal mini SAS connector on the cable into a SFF-8087 x4 internal mini SAS connector on the SAS 9260-8i RAID controller, as shown in Figure 2.5.

SAS Device Cables and Connectors

2-9

Copyright © 2009 by LSI Corporation. All rights reserved.

Page 47
Image 47
LSI 25083 manual Serial Attached Scsi SAS Backplane Receptacle Connector