LSI 25083 manual SAS 9260-8i/SAS 9260DE-8i RAID Controller Jumpers, JT1

Table 3.2		SAS 9260-8i/SAS 9260DE-8i RAID Controller – Jumpers
		and Connectors
Jumper	Type		Description
JT1	Write-pending Indicator		2-pin connector
	(dirty cache) LED		Connects to an LED that indicates when the
	connector
			data in the cache has yet to be written to the
			storage devices. Used when the write-back
			feature is enabled.
JT2	SAS Activity LED header		2-pin connector
			Connects to an LED that indicates drive
			activity.
JT3	Battery Backup Unit		20-pin connector
	connector		Connects the intelligent Battery Backup Unit
			LSIiBBU07 remotely to the RAID controller.
JT4	Global Drive Fault LED		2-pin connector
	header
			Connects to a single LED to indicate
			whether any drive is in a fault condition.
JT6	x4 SAS Ports 3–0		SFF-8087 x4 internal mini SAS connector
			Connects the cables from the RAID
			controller to SAS drives, SATA II drives, or a
			SAS expander.
JT7	x4 SAS Ports 7–4		SFF-8087 x4 internal mini SAS connector
	Note: The SAS 9260-4i		Connects the cables from the RAID
		RAID controller	controller to SAS drives, SATA II drives, or a
		does not have this	SAS expander.
		connector.
JT8	Modular RAID Key		2-pin connector
	header		Reserved for LSI use.
JT9	Set Factory Defaults		2-pin connector
	connector		Reserved for LSI use.
JT10	LSI Test header		2-pin connector
			Reserved for LSI use.
MegaRAID 6Gb/s SAS RAID Controller Family				3-5

Copyright © 2009 by LSI Corporation. All rights reserved.