Configuring the Cluster Node Network Adapter

Note: Which network adapter is private and which is public depends upon your wiring. For the purposes of this chapter, the first network adapter (Local Area Connection) is connected to the public network, and the second network adapter (Local Area Connection 2) is connected to the private cluster network. This may not be the case in your network.

Renaming the Local Area Connections In order to make the network connection more clear, you can change the name of the Local Area Connection (2). Renaming it will help you identify the connection and correctly assign it. Follow the steps below to change the name:

Step

Description

1Right-click on the Local Area Connection 2 icon.

2Click on Rename.

3Type Private Cluster Connection into the textbox, then press Enter.

4Repeat steps 1-3 to change the name of the public LAN network adapter to Public Cluster Connection.

5The renamed icons should look like those in the picture above. Close the Networking and Dial-up Connections window. The new connection names automatically replicate to other cluster servers as the servers are brought online.

Setting up the First Node in your Cluster Follow the steps below to setup the first node in your cluster:

 

Step

Description

1

Right-click on My Network Places, then click on Properties.

2

Right-click the Private Connection icon.

3

Click on Status. The Private Connection Status window shows the connection status, as

 

 

well as the speed of connection.

 

 

If the window shows that the network is disconnected, examine cables and connections

 

 

to resolve the problem before proceeding.

4

Click on Close.

4

Right-click Private Connection again.

5

Click on Properties.

6

Click on Configure.

7

Click on Advanced. The network card adapter properties window displays.

8

You should set network adapters on the private network to the actual speed of the

 

 

network, rather than the default automated speed selection.

 

 

Select the network speed from the drop-down list. Do not use “Auto-select” as the setting

 

 

for speed. Some adapters can drop packets while determining the speed.

 

 

Set the network adapter speed by clicking the appropriate option, such as Media Type or

 

 

Speed.

9

Configure identically all network adapters in the cluster that are attached to the same

 

 

network, so they use the same Duplex Mode, Flow Control, Media Type, and so on.

 

 

These settings should stay the same even if the hardware is different.

10

Click on Transmission Control Protocol/Internet Protocol (TCP/IP).

11

Click on Properties.

12

Click on the radio-button for Use the following IP address.

13

Enter the IP addresses you want to use for the private network.

14

Type in the subnet mask for the network.

15

Click the Advanced radio button, then select the WINS tab.

16

Select Disable NetBIOS over TCP/IP.

17

Click OK to return to the previous menu. Perform this step for the private network

 

 

adapter only.

 

 

 

 

Chapter 7 Cluster Installation and Configuration

79