Lucent Technologies 6 manual Pre-InstallationRequirements, CRCS/OpCe ter and OpCenterSP Checklist

CRCS/OpCenter and OpCenterSP Checklist

Pre-Installation Requirements

As a single-user dedicated system on a PC connected to one or two Lucent Tech- nologies MultiPoint Conferencing Units (MCU), CRCS/OpCenter or OpCenterSP can be set up as either local or remote.

For a local connection, the distance between the PC and MCU must be less than 5000 feet. Distances beyond 5000 feet are considered remote. Also, if the PC is not connected to the TN754B or TN2223 on the MCU side, the connection is remote.

CRCS/OpCe ter and OpCenterSP Checklist

Hardware Requirements

The system installed for single-user CRCS/OpCenter must be dedicated for CRCS/OpCenter use only. The following hardware components are required:

266 MHz Pentium II CPU with 64 MB RAM or greater recommended (mini- mum 100 MHz Pentium with 32 MB RAM)

1024 by 768 pixel resolution, 256 color, and small fonts

One 17-inch monitor (minimum 15 inch)

2.5GB hard disk with a high-speed drive and local bus controller (minimum

1.2GB)

One 1.44 MB 3.5 inch floppy disk drive

One 6X CD-ROM drive (minimum 4X)

A COM1 serial port with a 25-pin connector or a 9-to-25 pin adapter, if the COM1 port is 9 pin

A bus mouse or a serial mouse connected to a COM serial port

Optional laser or laser-quality printer connected to the LPT1 parallel port and installed as the default printer

Optional (highly recommended) backup tape or high capacity removable

ndisk device and appropriate software for the backup Slot for the fax hardware (optional)

SoftwarenRequirements

Microsoft Windows 95 or Windows NT 4.0 workstation with Service Pack 4

Issue 1 CRCS R6.0 April 1999 5