3.If your integrated amplifier or preamp has a ‘tape 2’ loop (sometimes called recording loop) or ‘Pre in/out’:
•Connect the output of the ‘tape 2’ loop / ‘Pre out’ to the input of the
•Then connect the output of the
Using this configuration enables you to use multiple audio sources without switching source and/or cables, since the ‘tape 2’ loop ‘Pre in/out’ is always active and not depending on other used inputs and outputs.
Source(s)
Integrated amp / Preamp-poweramp
RP-1
When using Option 2 or a ‘tape 2’ loop as described in Option 3, be aware that your amplifiers volume control is set at an appropriate level when making the RoomPer- fect calibration.
Please refer to the chapter “Setting the Measurement Volume Level” for further information.
13
