Pre Insert

•The Pre Insert point is located just before the channel DSP section.

•Used to insert a plug-in effect into the channel, pre-DSP.

•Click the Pre Insert drop-down box to select a plug-in from the available effects in the Effects Rack.

Note: One or more plug-ins must be installed in the Effects Rack (Ctrl+8) before a Pre Insert can be selected or None will appear in the drop-down box.

•If it’s a stereo effect, a channel can be assigned to the left or right input of the effect.

•The corresponding output of the effect is re- turned to the channel’s Pre Insert point.

Post Insert

•The Post Insert point is located just after the channel DSP section.

•Used to insert a plug-in effect into the channel, post-DSP.

•Click the Post Insert drop-down box to select a plug-in from the available effects in the Effects Rack.

Note: One or more plug-ins must be installed in the Effects Rack (Ctrl+8) before a Post Insert can be selected or None will appear in the drop-down box.

•If it’s a stereo effect, a channel can be assigned to the left or right input of the effect.

•The corresponding output of the effect is re- turned to the channel’s Post Insert point.

Direct Output

•The Direct Output is located after the channel DSP and just before the fader, mute, and pan controls.

•Click the Direct Output drop-down box to assign the selected channel’s Direct Output to the output of any I/O card.

Direct Out Level

•The Direct Output Level control corresponds

to the LEVEL TO TAPE V-Pot control on the console surface (T-OUT). It ranges from off (–∞) to +10 dB.

Manual Owner's

Owner's Manual

45