Digital X Bus

❏ Open Assign window (Windows > Assign) and

❏ Configure Auxes for desired Pre/Post status.

assign input sources for each channel used.

 

❏Select phantom power button in the Assign window for mic inputs if required.

Note: Condenser mics and active DIs use phantom power. Moving coil mics, ribbon mics, and most electronic instruments don’t need phantom power.

❏If using MIC/LINE cards, select –10 dB button on channels using line-level inputs.

❏Assign Fader Bank 1 (Channels 1-24) to Out- puts 25-48 (Options > Bank to Outputs > Out- puts 25-48). This routes all 24 inputs on Fader Bank 1 to the SLOT•B Outputs going to the multitrack recorder(s).

❏Select Setup (Windows > Setup) and set Mix Options.

❏Test each instrument and mic to verify suffi- cient level at console input meter.

❏Adjust input trim (Gain) for a reading around

–15 on the meter.

❏Select L/R in the ASSIGN BUTTON SETUP section to confirm Assign lights are on for all desired channels, or look on-screen to verify that all necessary channels have L/R button highlighted in Bus Assign section.

ASSIGN BUTTON

SETUP

REC

L - R

READ

WRITE

58 X.200