Makita DCS 7900 uwaste oil, and guide, Never Use Waste Oil, Avoid Skin And Eye Contact, It-1

Important note on bio-degradable chain oils

If you are not planning to use the saw again for an extended period of time. empty the Oil tank and Put in a Small amount of regular engine oil (SAE 30)3 and then

run the saw for a time. This is necessary to flush out all remaining bio-degradable oil from the oil tank, oil-feed

and guide as many such Oils tend to

leave sticky residues over time, which can cause dam-

It-1

uwaste oil &

A-

age to the oil pump or other parts.

The next time you use the saw, fill the tank with BIOTOP chain oil again. In case of damage caused by usingwaste oil

or unappropriate chain oil the product guarantee will be null and void,

Your salesman will inform you about the use of chain oil.

NEVER USE WASTE OIL

Waste oil is very dangerous for the environment.

Waste oil contains high amounts of carcinogenic substances.

Residues in waste oil result in a high degree of wear and tear at the oil pump and the sawing device.

In case of damage caused by using waste oil or unappropriate chain oil the product guarantee will be null and void.

Your salesman will inform you about the use of chain oil.

AVOID SKIN AND EYE CONTACT

Mineraloil products degrease your skin. If your skin comes in contact with these substances repeatedly and for an extended period of time, it will desiccate. Various skin deseases may result. In addition, allergic reactions are known to occur.

Eyes can be irritated by contact with oil. If oil comes into your eyes, immediatelywash them with clear water.

If your eyes are still irritated, see a doctor immediately!

Refuelling

		FOLLOW THE SAFETY PRECAUTIONS!
		Be careful and cautious when handling fuels.
		The engine must be switched off!
		Thoroughly cleanthe area around the caps, to prevent dirt from
		getting into the fuel or oil tank.
		Unscrew the cap and fill the tank with fuel (fuel/oil mixture) or
		chain oil as the case may be. Fill up to the bottom edge
		of the tiller neck. Be careful not to spill fuel or chain oil!
		Tightly screw on the cap.
		Clean screw cap and tank after refuelling.
&	fuelloil mixture	Lubricating the chain
chain oil		Duringoperationthere must always be sufficient chain oil in the
		chain-oil tank to provide good chain lubrication. One filling is
B		sufficient for about one half-hour of continuous operation.

22