(e)[Recoil starter model]
Pull the starter handle slowly until passing the compression point (resistance will be felt), then return the handle to its original position and pull briskly.
■If the engine fails to start after several attempts, repeat above procedures with choke lever returned to "OPEN" position.
■Do not fully pull out the rope.
■After starting, allow the starter handle to return to its original position while still holding the handle.
(f)[Electric starter model]
Insert the key into the key switch and turn it clockwise to the "RUN" position to start the engine.
Then turn the key further to the "START" position. The engine will be started by starting motor.
Pull | briskly |
|
STOP RUN
STOP | RUN | START | START |
|
|
［CAUTION］
■Do not run the starting motor over 5 seconds continuously.
If the engine fails to start, return the key to the "RUN" position and wait about 10 seconds then start again.
■Do not turn the key switch to "START" position when the engine is running to prevent damage of starting motor.
■When starting the engine by recoil starter, set the key switch at the "ON" position and pull the starter handle.
－12－
