Section 4 | Maintenance |
|
|
H.Remove the Bin Door
•Grasp the rear of the bin door and pull bin door forward approximately 5”.
•Slide bin door to the rear while applying upward pressure (The rear door pins will ride up into the track slot and slide backward to the stop tab).
•While applying pressure against the bin door pull down on the rear of each bin door track until the door pins clear the stop tabs.
•Slide the rear door pins off the end and then below the door track. Slide bin door forward allowing the back of the door to lower into the bin. Continue forward with the bin door until the front pins bottom out in the track.
•Lift right side of door until the front pins clear the track, then remove door from bin.
PRESS DOWN
TO RELEASE
DOOR
STOP TAB
TRACK SLOT
SLIDE DOOR
FORWARD
Step 7 Mix a solution of cleaner and warm water. Depending on the amount of mineral buildup, a larger quantity of solution may be required. Use the ratio in the table below to mix enough solution to thoroughly clean all parts.
Solution Type | Water | Mixed with |
|
|
|
Cleaner | 1 gal. (4 l) | 16 oz (500 ml) cleaner |
|
|
|
Step 8 Use ½ of the cleaner/water solution to clean all components. The cleaner solution will foam when it contacts lime scale and mineral deposits; once the foaming stops use a soft bristle brush, sponge or cloth (not a wire brush) to carefully clean the parts. Soak the parts for 5 minutes (15 – 20 minutes for heavily scaled parts). Rinse all components with clean water.
Step 9 While components are soaking, use ½ of the cleaner/water solution to clean all foodzone surfaces of the ice machine and bin. Use a nylon brush or cloth to thoroughly clean the following ice machine areas:
•Evaporator plastic parts – including top, bottom and sides
•Bin bottom, sides and top
Rinse all areas thoroughly with clean water.
Step 10 Mix a solution of sanitizer and warm water.
Solution Type | Water | Mixed With |
|
|
|
Sanitizer | 6 gal. (23 l) | 4 oz (120 ml) sanitizer |
|
|
|
Step 11 Use 1/2 of the sanitizer/water solution to sanitize all removed components. Use a cloth or sponge to liberally apply the solution to all surfaces of the removed parts or soak the removed parts in the sanitizer/water solution. Do not rinse parts after sanitizing.
Step 12 Use 1/2 of the sanitizer/water solution to sanitize all foodzone surfaces of the ice machine and bin. Use a cloth or sponge to liberally apply the solution. When sanitizing, pay particular attention to the following areas:
•Evaporator plastic parts - including top, bottom and sides
•Bin bottom, sides and top
Do not rinse the sanitized areas.
Step 13 Replace all removed components.
Step 14 Reapply power and water to the ice machine and place the toggle switch in the WASH position.
Part Number 000001130 12/08 |
