Marantz CDR632 manual Sync recording, Recording-Fade-in/out

5 – Recording—Fade-in/out

Fade-in/out Sync recording

When recording, you can fade-in the input signal from silence to the specified level, or fade-out from the current level to silence. The fade-in/out times can be specified independently.

FADER button

1As described in “Basic operation in Menu mode” (→ p.12), access the “FADE IN?” menu item and press the ENTER button.

The display will indicate “Fade In> XXs” (you can select 1–30).

Here you can specify the fade-in time.

2Turn the MULTI JOG dial to specify the fade- in time.

3Press the MENU button to return from menu mode to normal mode.

By selecting the “FADE OUT?” menu item in step 1, you can specify the fade-out time in the same way.

4To execute a fade-in, press the FADER but- ton on the front panel (or the remote control unit) from record-ready mode.

Recording will begin at the same time as the fade- in, and the display will indicate “Fade In”.

5To execute a fade-out, press the FADER but- ton on the front panel (or the remote control unit) during recording.

The fade-out will begin, and recording will stop when the fade reaches silence. The display will indicate “Fade Out” while the fade-out is occur- ring.

Note

You are able to operate fade-out during a fade-in, or fade- in during a fade-out.

Sync recording makes recording begin automatically when the input signal exceeds a specified level (the sync level) and end automatically when silence is detected at the end.

2

1, 4

1After entering record-ready mode (→ p.25), press the SYNC REC button repeat- edly to select “Sync ALL” or “Sync 1”.

Each time you press the button, the display will

cycle through the following settings: “Sync ALL” (repeatedly sync-record the input source) → “Sync 1” (sync-record only once) → “Sync OFF” (sync-record is off).

If “Sync ALL” is selected, the [SYNC] indicator in the display will light, and the CDR632 will be ready to sync-record.

If “Sync 1” is selected, the [SYNC] indicator in the display will blink, and the CDR632 will be ready to sync-record.

2If necessary, you can adjust the sync level as follows.

1As described in “Basic operation in Menu mode” (→ p.12), access the “SYNC LEVEL?” menu item and press the MULTI

JOG dial.

The display will indicate “S_LEV> XXXdB”.

2Turn the MULTI JOG dial to set the sync level. The range is –24 dB to –72 dB (6 dB steps).

3Press the MENU button or ENTER button to exit menu mode.

ENGLISH

27