5 – Recording—Sync recording
3 Begin playback on input source unit. |
After playback is begun on input source unit, the |
CDR632 will start recording automatically when |
If the sync level setting is too high, you may lose the first part of a song that begins softly.
ENGLISH
it detects audio signal which is above the sync |
level adjusted in step 2. However, after Sync1 or |
Sync ALL is selected, and if the signal below the |
adjusted sync level is not detected over one sec- |
ond, the CDR632 will not begin recording auto- |
matically even it detects the audio signal. |
level
Start of recording
level
S_LEV
Recording starts
This part of the track is not recorded
time
S_LEV |
noise level |
time |
Note
In this manual, we refer to audio below the currently specified sync level as “silence”.
When five seconds of silence occurs, the CDR632 will automatically enter
level
REC pause
5 seconds |
S_LEV |
time |
4To cancel sync recording, press the SYNC REC button to select Sync OFF.
Note
• | If “Sync 1” is selected, pressing the |
|
| (pause) but- | |
| ton will stop the disc and defeat the sync recording | ||||
| setting. |
|
|
| |
• | If “Sync ALL” is selected, pressing the |
|
| (pause) | |
|
| ||||
button will enter
•In either case, the sync recording setting will be
defeated if you stop by pressing the 
(stop) button.
Conversely, you should be aware that if the sync level setting is too low, the noise level of an analog source may be higher than the sync level, so that sync recording fails to start.
level
Start of track is not registered
Noise is higher than threshold
S_LEV
time
level
Division between tracks
S_LEV |
| Song you don’t |
| Song you want to record | |
| want to record | |
|
| |
|
|
|
|
| time |
28
