Marantz CDR632 What is finalizing?, Using the remote control unit, Introduction-Whatis finalizing?

What is finalizing?

Even after audio data is recorded on a CD-R or CD- RW disc, it cannot be played back on a conventional CD player until the final TOC(*) data has been recorded on the disc. The process of recording this TOC data is called “finalizing”.

No further recording can be performed on a finalized disc. However in the case of a CD-RW, the disc can be “un-finalized” to allow additional recording (→ p.31).

*TOC: Table of Contents = information about the recorded data, such as the number and playing times of the songs

Using the remote control unit

Cautions for use

•Remote control operations may not be possible if the remote control receiver is in direct sunlight or under intense illumination.

•Please be aware that operating the remote control unit may cause unintended operations to occur on other infrared-controlled equipment.

Installing the batteries

Open the cover on the back panel of the remote con- trol unit, and install two batteries (AAA size) in the correct orientation as indicated by the “+” and “-” markings on the case.

When to replace the batteries

If the range of control has lessened, or if pressing a button does not produce an operation, please replace both batteries with new ones.

1 – Introduction—What is finalizing?

Caution regarding batteries

Incorrect use of batteries may cause leakage or burst- ing. Please carefully read and observe the following cautions.

•Be sure to insert the batteries in the correct orien- tation as indicated by the “+” and “–” markings on the battery case.

•Do not mix new batteries with old batteries, or batteries of differing types.

•Never attempt to recharge batteries.

•Remove the batteries if you won’t be using the remote control unit for an extended period (more than one month).

•If leakage occurs, carefully wipe off any liquid from inside the case and install new batteries.

ENGLISH

7