Marantz CDR632 manual Auto track recording, Recording-Autotrack recording, Level, Digi, Minute

Auto track recording

Auto track recording is a function that automatically updates the track number when the specified condi- tion occurs.

1Select the auto track mode as follows.

1As described in “Basic operation in Menu mode” (→ p.12), access the “AUTO_TRK?” menu item and press the ENTER button. The display will indicate “A_Trk> XXX”.

2Use the MULTI JOG dial to select one of the following modes.

Level

The track number will be updated when the signal exceeds the specified auto track level after being below this level for two seconds or longer.

To specify the auto track level, use the “A_TRK LEVEL?” menu item. You can specify this level in the range of –24 dB to –72 dB (6 dB steps). When A_Trk=Level, the [A•TRACK] indicator in the display will light.

At least 2	Track
	increment
seconds
level
S_LEV
	time

Digi

When recording a digital source (CD, DAT, MD), the track number will be updated when a track boundary has been detected in the source.

When A_Trk=Digi, the [A•TRACK] indicator in the display will light.

However if an analog source is being recorded even though Digi is selected, or when recording a digital source other than the above, the track num- ber will be updated according to the input level in the same way as with the “Level” setting described above.

5 – Recording—Auto track recording

Minute

The track number will be updated when the speci- fied length of time has elapsed after recording began. Use the “A_TRK TIME?” menu item to specify this length of time.

When A_Trk=Minute, the [A•TRACK] indicator in the display will light.

The [A•TRACK] indicator will blink while record- ing and in record-ready mode.

2If you selected “Level” as the auto track mode, proceed as follows to set the auto track level.

1As described in “Basic operation in Menu mode” (→ p.12), access the “A_TRK LEVEL?” menu item and press the ENTER button.

2Turn the MULTI JOG dial to set the auto track level in a range of –24 dB to –72 dB (6 dB steps).

3Press the MENU button or ENTER button to exit menu mode.

3If you selected “Minute” as the auto track mode, proceed as follows to specify the time interval for updating the track number.

1As described in “Basic operation in Menu mode” (→ p.12), access the “A_TRK_TIME?” menu item and press the ENTER button. The display will indicate “TR_TIME>XXm”.

2Turn the MULTI JOG dial to select “1m” (1 minute), “5m” (5 minutes), “10m” (10 minutes), “15m” (15 minutes), or “30m”

(30 minutes) as the time interval.

3Press the MENU button or ENTER button to exit menu mode.

In this condition, the track number will be updated when the input signal meets the speci- fied conditions, or when the specified interval of time has elapsed since recording began.

Note

You can’t change the TR_TIME setting during recording.

ENGLISH

29