Connect and playback from a digital
device (COAX/OPT1/OPT2)
1Press COAX, OPT1 or OPT2 to switch the input source
to “COAX”, “OPT1” or “OPT2”.
The digital audio signal that is being input is shown as follows in the
display.
“COAX or “OPT1 or “OPT2
xxxxk” xxxxk” xxxxk”
(xxxx is the sampling frequency.)
0If the sampling frequency cannot be detected, “Unlocked” will be
displayed.
0“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
oFiles that can be played back
See “D/A converter” (v p. 62).
NOTE
0Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise
and could damage the speakers.
0If the sampling frequency switches, such as from A mode to B mode in a CS
broadcast, muting may operate for 1 – 2 seconds, cutting the sound.
Contents Connections Playback Settings Tips Appendix
37
Front panel Display Rear panel Remote Index