Marantz SR9600 manual Learning Commands, Learn Sequence, Tip

LEARNING COMMANDS

If an IR code or a brand is not in the database, you can program RC3200B commands by transmitting IR signals from your existing remote control units to the RC3200B's learning eye. To do this, place the RC3200B and the device's remote control unit on a flat surface, 1 - 4 inches (2.5 - 10 cm) apart.

OK		NO GOOD
Top View		Top View	RC3200B
DVD remote		DVD remote
	RC3200B
control unit		control unit
Side View		Side View
DVD remote		DVD remote
control unit	RC3200B	control unit	RC3200B
1 - 4 inchs (2.5 - 10 cm)

To learn commands from other remote control units, RC3200B has to be in Learn mode. Switching to Learn mode is only possible from the Mode screen.

See “WORKING WITH MODES”. (See page 17)

For each device, you can learn all soft and hard buttons on the RC3200B, except for:

•the BACKLIGHT button

•the page up and page down buttons

•the buttons to navigation bar

•the S button

THE LEARN SEQUENCE

1. Set the RC3200B to the Use mode. See “WORKING WITH MODES”.

2. Select the device, e.g. DVD, with the buttons you want to learn. The device screen appears.

3. Press and hold the Mode button for 3 seconds. The Mode screen appears.

4. Tap Learn on the Mode screen.

LEARN

1/4 DVD Main

Done BWD FWD

The RC3200B is now in the Learn mode. “LEARN” and the label of the selected device appear at the top of the LCD touch screen.

5. Use, if necessary, the page up or page down button to go to the next button you want to learn.

6. Press the soft or hard button you want to learn on the RC3200B.

T h e “ L E A R N ” l a b e l c h a n g e s t o “LEARNING”, which means RC3200B is ready to receive commands from an existing remote control unit.

The RC3200B will wait for 5 seconds to receive an IR code from another remote control unit.

Note:

When a hard button is pressed to learn, there is no onscreen feedback to indicate which button is pressed.

7. Press and hold the button on the existing remote control unit you want to learn to the RC3200B.

When the RC3200B receives an IR code:

•A confirmation beep will sound.

•The label changes from “LEARNING” to “OK”. The learn sequence is successful.

OK

1/4 DVD Main

Done BWD FWD

When the RC3200B does not receive an IR code within 5 seconds:

•An error beep will sound.

•The label changes from “LEARNING” to “FAILED”. The learn sequence has failed.

•The RC3200B will return to the Learn mode. Return to step 5 of the learn sequence to relearn the button.

Tip:

You do not have to wait for the “OK” or “FAILED” to disappear. If you press another button (soft or hard), the RC3200B learn sequence immediately goes back to step 5.

8. Go to other pages of the selected device with the page up and page down buttons. Repeat steps 6 and 7 until you have copied all the commands of the existing remote control.

9. Press Done button when you have finished learning commands on the buttons of your choice.

The RC3200B returns to the Use mode. You can try out the new IR codes or select another device to learn.

ENGLISH

19