MaxTech V.32bis, V.42bis user manual Switch to reliable link from normal link

\Y		Switch to reliable link from normal link
\Z		End the reliable connection and switch to
		normal operation
-J	-J0	Disable error control detection phase
	-J1	Enable error control detection phase
"H	"H0	V.42bis data compression disabled
	"H1	Can send but not receive V.42bis data
		compression
	"H2	Can receive but not send V.42bis data
		compression
	"H3	Bidirectional V.42bis data
		compression enabled
"On	n=6-	Set maximum V.42bis data block size to n.

250Default is 16

3.6Fax Class 1 Commands

+FAA=n	Data/Fax auto answer enable. Default is 0
+FAE=n	Data/Fax auto answer enable. Default is 0
+FCLASS?	Returns current operating mode
+FCLASS=n	Sets operating mode
+FCLASS=?	Returns available supported modes
+FMFR?	Identify modem manufacturer
+FMDL?	Identify product model
+FPREV?	Identify product revision
+FRH=<mod>	Receive HDLC data
+FRHM=<mod> Receive data
+FRS=<time>	Wait for silence
+FRTn	Fax receive test command
+FTH=<mod>	Transmit HDLC data
+FTM=<mod>	Transmit data
+FTS=<time>	Stop transmission and pause
+FTTn	Fax transmit test command

3.7 Voice Mode Commands

#VBP	Generate beep tone
#VCL=n	Voice mode selection. Default is 0
#VCSD=n	Command mode silence detection. Default is 0
#VGPS=n	Input pin function selection. Default is 0
#VGPC=n	Input pin character selection. Default is 0
#VIN	Read general purpose input pins
#VIP=n	Initialize parameter. Default is 0
#VLN=n	Relay/speaker control. Default is 0
#VOUT=n	Write to output pins. Default is 0

11