Main
User's Manual
1
Section One - Introduction
Figure 2-1 Common Serial Ports
Section Two - Installation
2.1 Unpacking Your Modem
2.2 Hardware Installation
2
2.3 Software Installation/Configuration
Figure 2-2 Expansion Slots
Page
4
2.4 COM Port and Interrupt Settings
SW-1
Table 2-1 Switch Block Settings
Figure 2-3 Switch Block SW-1 Location
5
2.5 Using Fax, Voice, and Speakerphone Capabilities of the Modem
2.6 Testing Your Modem After Installation
2.7 Using Your Modem
6
Section Three - AT Command Set
3.1 Executing Commands
3.2 Command Structure
7
3.3 Basic AT Commands
In the following listings, all default settings are printed in bold text. Command Function
8
3.4 Extended AT Commands
Page
10
3.5 MNP/V.42/V.42bis Commands
11
3.6 Fax Class 1 Commands
12
3.7 Voice Mode Commands
Setion Four - S Registers
13
Table 4-1 S - Registers Register Function Range/units Default
Section Five - Result Codes
14
BASIC RESPONSE CODES
MODIFIED RESPONSE CODES (\V1)
EXTENDED RESPONSE CODES (\V2)
15
Section Six - Troubleshooting
Modem does not respond to commands.
Modem does not dial.
Modem dials but does not connect.
Page
17
Section Seven - Specifications
Section Eight - Support and Service
Section Nine - FCC , DOC & Other Notices
9.1 FCC Compliance
18
9.2 FCC Class B Statement
9.3 DOC Compliance Information
19
9.4 Disclaimer, Copyright, And Other Notices
1
Section One - Introduction
Figure 2-1 Common Serial Ports
Section Two - Installation
2.1 Unpacking Your Modem
2.2 Hardware Installation
2
2.3 Software Installation/Configuration
Figure 2-2 Expansion Slots
3
2.4 COM Port and Interrupt Settings
Page
5
2.6 Testing Your Modem After Installation
2.7 Using Your Modem
2.8 Where To Go From Here
6
Section Three - AT Command Set
3.1 Executing Commands
3.2 Command Structure
3.3 Basic AT Commands
Page
8
3.4 Extended AT Commands
9
3.5 MNP/V.42/V.42bis Commands
Page
11
3.6 Fax Class 1 Commands
3.7 Voice Mode Commands
12
Setion Four - S Registers
Table 4-1 S - Registers Register Function Range/units Default
13
Section Five - Result Codes
BASIC RESPONSE CODES
MODIFIED RESPONSE CODES (\V1)
EXTENDED RESPONSE CODES (\V2)
14
Section Six - Troubleshooting
Modem does not respond to commands.
15
Modem does not dial.
Modem dials but does not connect.
Modem makes a connection but no data appears on your screen.
High pitch tone is heard whenever you answer the phone.
Section Seven - Specifications
17
Section Eight - Support and Service
Section Nine - FCC , DOC & Other Notices
9.1 FCC Compliance
9.2 FCC Class B Statement
18
9.3 DOC Compliance Information
19
9.4 Disclaimer, Copyright, And Other Notices