Maytag ARB2557CC How to reverse the doors, Standard Door Design, Doors With Curved Contour Design

How to reverse the doors

STANDARD DOOR DESIGN

1.Perform all steps listed in How to

Remove the

Doors and Hinges (page 4).

2. Transfer cabinet plugs and cabinet screws to opposite side of cabinet.

• Remove cabinet plugs with flat blade of screw- driver tip wrapped in masking tape.

•Remove center mullion screws with

5⁄16" hex head screwdriver.

•For swing doors only: Remove bottom mullion screws with 3⁄8" hex head driver.

CAUTION

To avoid possible injury and damage to property:

➢Place doors on a nonabrasive surface protected by towels or rugs while working directly on doors.

3.Transfer door stops from bottom edge of fresh food door and freezer door (some models) to opposite side of door edge.

•Use a Phillips

screwdriver for removal and

installation.

4.See How to Install and Remove Handles (page 6) to remove and reinstall handles.

5.Proceed to How to Replace the Doors and Hinges to mount doors (page 7).

DOORS WITH CURVED CONTOUR DESIGN

1.Perform all steps listed in How to

Remove the Doors and Hinges (page 4).

2.Transfer cabinet

plugs and screws to opposite side of cabinet.

•Remove plugs with flat blade of screwdriver wrapped in masking tape.

•Remove center mullion screws with

5⁄16" hex head screwdriver. screwdriv- er.

CAUTION

To avoid possible injury and damage to property:

➢DO NOT remove sub cap when removing door trim.

➢Place doors on nonabrasive surface protected by towels or rugs while working directly on doors.

3.Remove door stop from fresh food door with Phillips

screwdriver.

4.Remove bottom door trim by removing 4 Phillips screws. Lift handle corner of trim and slide toward hinge edge of door.

5.Remove top door trim by removing 4 screws*. Lift handle corner of trim and slide toward hinge edge of door.

•Retain all screws for later use.

6.Reverse handle by removing two screws* from top and bottom edge of handle and reattaching handle on opposite side of door.

7.Install top door trim on bottom side of door, and bottom trim on top side of door.

•Locate hinge hole corner of trim. Install hinge hole corner of trim on hinge side first, then install handle edge of trim.

8.Proceed to How to Replace the Doors and Hinges (page 7).

*Fasteners may require either a T-15 Torx® driver or a Phillips screwdriver. Torx® is a registered trademark of Textron Inc.

5