Disassembly Procedures
!WARNING
4.Use the Brake Tool to unscrew the Brake Package assembly from the Damper. When the Brake Package is free, pull out to disengage it from the spline surface of the drive tube.
5. Use a hammer to remove the Brake Package.
To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing.
Drive Pulley and Rotor Bearing
1.Disconnect power supply to unit.
2.Remove Drive and Pump Belts and Dust Cap covering hub of Pulley.
3.Remove screw and washer from bottom of Drive Shaft.
4.Remove the splined Drive Lug from the Drive shaft.
5.Turn pulley counterclockwise to remove it from the Helical Shaft. The Rotor Bearing is located above the drive pulley.
Note: There is a top and bottom to the rotor bearing. When it is positioned correctly, the top of the Bearing and the Pulley hub will be about even (the concave side against Pulley hub).
! WARNING
To reduce the risk of serious injury or death to persons when using your washer, make sure the Rotor Bearing is not put on upside down. You will have no Brake.
6.After Brake Package has been removed, the Radial Bearing may be removed from top of Brake package.
Belts
1.Disconnect power supply to unit.
2.Remove front Panel.
3.Tilt machine backwards.
4.Roll Pump Belt than Drive Belt off pulleys.
Note: When the drive Pulley is replaced, the Drive Lug must be properly positioned.
28 | 16022842 Rev. 0 | ©2003 Maytag Appliances Company |
