Disassembly Procedures
!WARNING
Pump
1.Disconnect power supply to unit.
2.Remove Front Panel.
3.Disconnect hoses from pump.
4.Tape washer lid to Top Cover.
5.Tilt washer and remove Pump Belt.
6.Remove three screws from bottom of base holding pump to base. The mounting holes for the pump on the base frame are slotted for adjustment of the Pump Belts.
Note: Mark the general position of pump before removing.
7. Tilt pump and lift through access hole in base frame.
Drive Motor and Motor Base
1.Disconnect power supply to unit.
2.Remove Front Panel.
To avoid risk of electrical shock, personal injury or death; disconnect power to unit before servicing.
3.Remove Motor Cover.
4.Remove main wiring harness from motor terminals.
Note: DO NOT remove the wires going from motor switch to motor.
5.Remove Belts.
6.Remove three screws holding motor base to base frame.
7.Remove Motor and Motor Base.
8.Remove Pulley from Motor.
9.Disengage tension springs and remove mounting nuts.
Note: To remove two of the nuts, align upper and lower sections and insert wrench through the slots into lower section.
10. Lift Motor Base off Motor.
Note: With Motor removed, carriage and slides are accessible for service.
©2003 Maytag Appliances Company | 16022842 Rev. 0 | 29 |
