Mazda 4WD manual Safety belt maintenance

JOBNAME: No Job Name PAGE: 76 SESS: 1 OUTPUT: Tue Apr 12 14:52:56 2005 /ford_pdm/ford/own2002/mbs/mpdiff

Seating and Safety Restraints

5.At a moderate speed, buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled.

•After Step 5 the safety belt warning light will be turned on for three seconds.

6.Within seven seconds of the safety belt warning light turning off, at a moderate speed, buckle then unbuckle the safety belt.

•This will disable BeltMinder™ if it is currently enabled, or enable BeltMinder™ if it is currently disabled.

7.Confirmation of disabling BeltMinder™ is provided by the safety belt warning light flashing four times per second for three seconds.

8.Confirmation of enabling BeltMinder™ is provided by:

•The safety belt warning light flashing four times per second for three seconds.

•Followed by three seconds with the safety belt warning light off.

•Once again, the safety belt warning light will flash four times per second for three seconds.

9.After receiving confirmation, the deactivation/activation procedure is complete.

Safety belt maintenance

Inspect the safety belt systems periodically to make sure they work properly and are not damaged.

NOTE: If unsure about the proper procedures, bring your vehicle to an authorized Mazda dealership for inspection. Inspect the safety belts to make sure there are no nicks, tears or cuts, replacing if necessary. Check all automatic locking retractors on all outboard seating positions as well as the automatic locking mode for child safety seats on the passenger front belt. All safety belt assemblies, including retractors, buckles, front seat belt buckle assemblies, buckle support assemblies (slide bar-if equipped), shoulder belt height adjusters (if equipped), shoulder belt guide on seatback (if equipped), child safety seat tether bracket assemblies (if equipped), LATCH child seat tether anchors and lower anchors (if equipped), and attaching hardware, should be inspected after a collision. Mazda recommends that all safety belt assemblies used in vehicles involved in a collision be replaced. However, if the collision was minor and an authorized Mazda technician finds that the belts do not show damage and continue to operate properly, they do not need to be replaced. Safety belt assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted.

76

CIMS #1112659 com_belt-maint.mbs

itdseq=114

PAGE: 76 OP: root EDIT SESSION: 1 DATE: APR 12 2005 at 14:52 JOB: @ibm2/ford_pdm/CLS_ford/GRP_own2002/JOB_mbs/DIV_mpdiff

DIFF-MARKED Review Copy ÐÐ

(OLD=2005 B-Series fus Owners Guide (post-2002-fmt) 2nd Printing (#24721) (Nov-24-2004 11:18:53))

(NEW=2006 B-Series fus Owners Guide (post-2002-fmt) 2006 MBS CNE (#NoEntry) (Apr-12-2005 14:48:18)) 2006 B-Series(mbs), Owners Guide (post-2002-fmt)(own2002), Market: USA (fus)