McIntosh C200 manual How to Operate the Setup Mode, Default Settings, Display Brightness

Figure 1

How to Operate the Setup Mode

Your McIntosh C200 has been factory configured for de- fault operating settings that will allow you to immediately enjoy superb audio without the need for further adjust- ments. If you wish to make changes to the factory default settings (refer to the adjacent page), a Setup Feature is pro- vided to customize the operating settings using the Front Panel Alphanumeric Display on the C200C Controller.

1.Press the POWER switch to ON, the Red LED above the STANDBY/ON push-button

lights to indicate the C200 is in Standby mode. To turn on the C200 press the STANDBY/ON

push-button. Refer to figure 1.

2. Press the C200 Front Panel

SETUP push-button. The LED above the SETUP Push- button will illuminate and the Front Panel Display will indicate DISPLAY 20. Refer to figure 2.

Note: The Front Panel Display will indicate DISPLAY 20 the first time, after then it will display what ever Setup Mode was last accessed.

Figure 2

3.Rotate the BALANCE Control and notice that the Setup Mode advances through eight different possible adjustment selections and one informational display.

4.To exit from a specific Setup Mode press the SETUP Push-button a second time, the LED above the SETUP Push-button will extinguish and the Front Panel Dis- play will revert back to its normal display. Refer to fig- ures 3.

Figure 3

Default Settings

The following listings indicate the default settings and the page number for instructions on how to change a setting.

Setup Function Name	Setting	Page Number
Brightness (Display)	20	18
Text (Display Options)	Full	18
Trim (Input Level)	00	19
Input (On/Off)	On	19
Volume (Rate-of-Change)	VRV	20
Balance (Rate-of-Change)	VRB	20
Passthru (Multichannel)	Off	20
Remote (Control Type)	Norm	21
Version (C200 Firmware)	_ . _ _	21

Display Brightness

The Front Panel Alphanumeric DISPLAY Brightness may be varied from a setting of 1(Dim) to 31(Bright), follow the steps below for changing the brightness. Refer to figure 4.

Figure 4

1.Press the SETUP Push-button to access the Setup Mode.

2.Rotate the BALANCE Control Knob until the word DISPLAY 20 appears.

3.Rotate the LISTEN Switch Knob until the desired Dis- play Brightness is achieved.

4.Press the SETUP Push-button to exit the Setup Mode.

Text Display Options

There are two choices for the displaying of Input Names on Front Panel Alphanumeric Display, TEXT FULL or TEXT SHORT. The TEXT FULL Mode displays the Volume Set- ting together with the name of the Listen Input Selected.

Refer to figure 5. The TEXT SHORT Mode displays the name of Record Input Selected, the Volume Setting and the name of the Listen Input Selected. Refer to figure 6.

Figure 5

Figure 6

1.Press the SETUP Push-button to access the Setup Mode.

2.Rotate the BALANCE Control Knob until the words TEXT FULL appears. Refer to figure 7.

3.Rotate the LISTEN Switch Knob until the display indi- cates TEXT SHORT. Refer to figure 8.

4.Press the SETUP Push-button to exit the Setup Mode.

Figure 7

Figure 8

18