McIntosh C200 manual Setup

turn On.	3KRQR￿￿￿￿￿$X[￿￿			￿	Setup
Input Trim Level
			Indication will automatically move up or down
Various components can have slightly different volume
levels. This could result in the constant need to readjust the			when changing between Input Sources to reflect the
C200 volume control when switching between different			differences in trim levels. The Trim Level can also
Listen Program Sources. A volume trim feature on the			be set via the remote control. The following table
			may be used to record your level trim adjustments
C200 allows you to adjust or trim the levels of the various
			for the various inputs.
inputs so that they have the same relative volume. The
Phono1 Input is used in the example below.	,			'HIDXOW6HWWLQJ	1HZ￿6HWWLQJ
Note: The possible range of adjustment in volume level is ±
		SXW￿6RXUFH
12dB. The Record Output Levels are uneffected by any
changes in the Trim Settings. Any TRIM adjustments
made are retained in permanent memory and can be
changed only by performing a new TRIM procedure.
	7DSH
1. Rotate the LISTEN Switch Knob to select the Phono1
Input and adjust the VOLUME Control to the desired	/LQH￿￿
listening level.
2. Press the SETUP Push-button to access the Setup
Mode.
3. The Front Panel Alphanumeric Display will change
and the Red LED above the SETUP Push-button will
4. Rotate the BALANCE Control Knob until the words
	Input Selection
TRIM 00 PH1 appears. Refer to figure 9.
	The C200 allows the turning off of unused Input Sources.
	This prevents having to go through all the eight positions
	on the LISTEN and RECORD Switches when there may
Figure 9
	only be four Input Sources Connected to the C200. The
5. Rotate the VOLUME Control until the desired volume	Phono 1 Input is used in the example below.
	Note: If all the Input Sources have been turned Off and the
level is achieved. Refer to figures 10 and 11. Figure 10
			C200 is no longer in the Setup Mode, the Front Panel
indicates a +3dB increase in the PH1 Level and figure			Display will Indicate NO SOURCE. Two Input Positions
11 has a -5dB decrease in level.			on the C200 have a Rear Panel Slide Switch associated
Note: Choose a Input Source that is frequently listened to			with them. This allows selection of three additional
as the reference. The reference Input Source should			component sources to be connected, however only eight
be set to a Trim Level of 00.			possible Input Sources can be selected from at any one
			time.

Figure 10

Figure 11

6.Rotate the LISTEN Switch Knob until the next desired Input Source Name is displayed.

7.Repeat steps 3 and 4 until all the Inputs with sources connected to the C200 have the same relative volume levels when switching between them.

8.Press the SETUP Push-button to exit the Setup Mode.

1.Rotate the LISTEN Switch Knob to select the Phono1 Tuner Input.

2.Press the SETUP Push-button to access the Setup Mode.

3.Rotate the BALANCE Control Knob until the words INPUT ON PH1 appears. Refer to figure 12.

Figure 12

4.Rotate the LISTEN Switch Knob until the desired In- put Source Name that you want to turn Off is dis- played.

Note: Whenever a program source selected has trimmed volume levels, the Front Panel Display Volume

19