Mute
Press the MUTE push-button to mute audio in all LISTEN outputs.
Mono
Press the MONO push-button to combine left and right ste- reo signals to mono at all MAIN, AMPLIFIER, LISTEN and HEADPHONES Outputs.
Input Selection
Press any of the eight Input push-buttons to select a LIS- TEN program source.
Transport Functions
Use the Transport Function Push-buttons to operate a CD player, CD changer or tape recorder.
Note: Non-McIntosh CD, DVD and Tape Recorder Components may be controlled with the C200 Remote Control when they are connected together with a McIntosh RCT Translator. Refer to the RCT Owner’s Manual for further information on alternate Remote Control push-button functions.
Numbered and +10 Push-buttons
Press push-buttons 0 through 9 to access tuner station pre- sets, CD tracks or CD discs. When using a McIntosh CD player, access track numbers higher than 10 by first press- ing +10 and then a number push-button.
Disc and Track
Use the DISC and TRACK push-buttons when a CD player or changer is being used.
Tuner Functions
Select AM or FM broadcast band. Press and release SEEK Up or Down to move from station to station. Press and hold a SEEK push-button to move continuously from station to station. Press REVIEW to start the automatic brief audition of each of the presets stored in the tuner memory. Press REVIEW a second time to stop on a station preset and exit the Review process.
Note: Non-McIntosh Tuners may be controlled with the C200 Remote Control when they are connected together with a McIntosh RCT Translator. Refer to the RCT Owner’s Manual for further information on alternate Remote Control push-button functions.
panel connections to add signal processing from an exter- nal processor to the RECORD outputs.
Record Monitor
Press the REC (Record) MONitor push-button to listen to the signals being fed to the RECORD OUTPUTS.
Volume
Press the Up or Down VOLUME push-button to raise or lower the listening volume level. The Record Outputs are not affected.
Trim
Press the TRIM push-button to enter the C200 Setup Trim Mode. Press a second time to exit the Setup Trim Mode.
Note: Refer to the Setup Section contained elsewhere in this Owner’s Manual.
Display
Press the DISPLAY push-button to cycle the Volume Dis- play between dB and % of volume indications.
Accessory Power Control
Press ACCessory ON or ACCessory OFF to turn Power On and Off with some McIntosh Source Components and non- McIntosh Source Components that are connected with a McIntosh RCT Translator.
Note: Only the ACC ON push-button is active with the McIntosh LV or DVD Disc Player.
Optional Remote Control
If the C200 is used in the Passthru Mode, an optional McIntosh Remote Control Model
UR12 allows an Alternate Set of Re-
mote Control Codes for the C200 to be used. This will prevent the C200 from responding to the Remote Con- trol that comes with the McIntosh A/ V Control Center or Surround De- coder. See your McIntosh Dealer for
additional information. Refer to figure 27.
27