Meco 6212S00T91, 6512S0DT91 manual Step Tank Blocking Wire Assembly

19

!WARNING

To reduce the risk of serious bodily injury or death from fire or explosion:

Never remove guards or devices to prevent storage of spare or oversize LP Gas Cylinders not recommended for this grill.

Step 21

Tank Blocking Wire Assembly

Attach the Tank Blocking Wire to the cart as follows. 1) Insert the Z shaped end into the hole in the bottom flange of the control panel inside the cart. 2) Rotate the Wire so that the first leg is resting on the control panel flange. 3) Align the loop end over the hole in the short top flange of the lower back Crossbrace. Fasten in place with 1) 5/32-30 x .39” Bolt per Wire. Insert the bolt through the wire loop and into the tapped hole in the Crossbrace flange.

1

5/32-30 x .39” Bolt

1 pc

Tank

Blocking

Wire

center Tank Blocking Wire

23

Bolt

Note:

Install 2 Tank Blocking Wires on

Model 6512.

To attach the center Tank Block- ing Wire, use the same bolt that fastens the Center Crossbrace to the lower back Crossbrace in Step

6.Remove the bolt then re-install it through the Tank Blocking Wire, Crossbrace and into the Center Crossbrace.

Center Crossbrace