Meco 8452-5-SS1 manual Lighting the Grill Using PULSE-SPARK Ignitor, Lighting with Ignitor

LIGHTING THE GRILL USING

THE PULSE-SPARK IGNITOR

To reduce the risk of serious bodily injury or death:

·Open Hood before lighting the grill to prevent an explosion from gas build-up.

·During failed lighting attempts, or if the burners go out during operation, turn control knobs “Off” to dissipate any accumulation of gas. Wait five minutes before repeating lighting procedure.

1.Open the Hood.

2.Important: Make sure control knobs are turned “Off”. (FIG. 17B)

3.Turn the LP Gas Cylinder valve open counter clockwise until it stops. (FIG. 17A)

4.Push far left control knob in and turn counter clockwise to the High position. (FIG. 17C &17D)

5.Pause 4 seconds and push the ignitor button in for

2-3 seconds to light the burner. Listen for the spark ignition and look to make sure the burner is lit.

If no spark, see (FIG. 17E) and Troubleshooting Section.

6.From the “Off” position, light all other burners from left to right, making sure each burner is lit before lighting the next. Your grill has a crossover ignition system that allows the burners to light successively off one another. Confirm each burner is lit before lighting another burner.

7.If the burner fails to light, repeat Step 3. If it still does not light, try the next burner from left to right.

If a burner goes out during operation, turn all knobs to the “Off” position and close the LP cylinder valve or the natural gas supply valve to dissipate any accumulated gas. Open hood and wait five minutes before attempting to relight the grill.

If any or all burners fail to light after three or four attempts following Steps 4-7, turn all knobs to the “Off” position and close the LP gas cylinder valve to dissipate any accumulated gas. Wait five minutes; then

Control Knob

in OFF

position

FIG. 17B

Lighting with Ignitor

Right Control Knob

Left Control Knob

	Ignitor Button
FIG. 17C

Control Knob on

High position

(large flame

symbol)

FIG. 17D

repeat the lighting procedures. NOTE: If the burners still fail to light, refer to the Troubleshooting Section. The burner can also be lit manually, see Manual Lighting of the Grill.

Turn LP Gas Cylinder valve counter-clockwise.

3/16” Gap

FIG. 17E

Gas Collector Box-If no spark, pinch together or open Gas Collector Box to adjust 3/16” gap between electrode tip and V-notch.

FIG. 17A

16