Meco 8452-5-SS1 manual Caster Assembly, Door Assembly

STEP 4) CASTER ASSEMBLY:

Lay cart on the floor with Back Panel side down. Assemble Fixed Casters (23) to the LEFT Side of Bottom Panel and Swivel Lock Casters (24) to the RIGHT Side of Bottom Panel. Insert eight M6x15 Bolts (7) through the caster bracket holes into the threaded holes in the Bottom Panel. (FIG. 4A & 4B) Tighten the screws. Push the lever on the Swivel Lock Caster to lock so the caster wheel does not roll. (FIG. 4C) Set cart assembly up on the the floor.

(7) M6 x 15 BOLT

(23)FIXED CASTER

(24)LOCKING CASTER

PUSH LEVER	PUSH LEVER
DOWN THIS	DOWN THIS
SIDE TO LOCK	SIDE TO
	UNLOCK

FIG. 4C

FIG. 4A

FIG. 4B

STEP 5) DOOR ASSEMBLY:

Install LEFT Door (26/27) and RIGHT Door (28/29). (FIG. 5A) Note: Hinge Pins are spring-loaded. Drop bottom door pin into Bottom Panel hole. (FIG. 5B) Swing top of door toward hole in top Panel. Depress spring pin with thumb while sliding pin into Top Panel hole until it snaps into place. (FIG. 5C)

(26/27) LEFT DOOR SHOWN,

RIGHT DOOR SAME.

FIG. 5C

FIG. 5B

7

FIG. 5A