MCD4300BT.2002.O/M.QXD 4/19/02 9:57 AM Page 7
INSTALLATION INSTRUCTIONS (CONTINUED)
Installation of the Rechargeable Battery
1
2
Remove the battery cover located on the rear of the handset by sliding it downward.
If replacing an old battery pack, unplug the battery connector and remove it by carefully using a small flat head screw- driver to pry it out from the battery compartment.
3
4
Plug the new battery into the rechargeable battery plug and insert the rechargeable battery into the battery compartment. Make sure cable connector is inserted into the slot correctly and securely.
Put the battery cover back on by sliding it upward until it clicks in place.
Charging the Rechargeable Battery
It is recommended that the rechargeable battery be fully charged overnight prior to initial use. The handset’s rechargeable battery will be charged when it’s on the base’s charge contacts; the Base LED indicator will light.
The battery low indicator will light in the display and a beep will be heard when using the handset and the battery power is low and needs recharging.
NOTES:
•If the battery does not appear to be charging please insure the cable connector of the battery is inserted correctly and securely. The display will still read “Charging” and the base LED will light up as long as the contacts of the phone and base are touching even if the battery is not properly connected so this does not insure proper charging.
•Every few months, or when charging becomes abnormal, clean the contacts of the handset and the base with a standard pencil eraser.
7
