Memorex MVDR2100 manual Connection

CONNECTION

CONNECTING THE DVD TO A TV AND CATV USING THE RF INPUT/OUTPUT JACKS

IMPORTANT:

This will only send the cable/satellite signal to the TV. To play a disc, you must connect using the A/V, S-Video or component outputs as described on the following pages.

Coaxial Cable (Not Included)

From Source (i.e. cable, etc.)

Coaxial Cable (Not Included)	To
	RF IN

From

RF Out

To RF IN

NOTES FOR CONNECTING TO CATV, SATELLITE, ETC.

•The signal will be sent to the TV regardless if the DVD recorder is on or off.

•If your TV has a Component input, connect the DVD recorder with the component cable for best results, otherwise use the S-Video or Video Out jack(s) on the DVD recorder.

•You can use the DVD recorders tuner to change channels, or you can use your TV’s tuner.

•When connecting the DVD, refer to the owner’s manual of the TV, as well as this manual.

•When connecting the DVD to the TV, make sure the power is off and both units are unplugged before making any connections.

•Connect the DVD recorder to your TV directly. If you connect the DVD recorder through a VCR, the playback picture will be distorted because DVD video discs are copy protected.

•Connect a cable, etc. signal as described on this page to use the tuner capabilities of this unit and one of the OUT video connections on the CONNECTION pages to play a disc. If your TV only has an RF input, then an RF Modulator Accessory RF-150 will be required.

•After connecting, press the SOURCE button to select TV, “CH” and a channel number will appear on the TV.

9