Choosing standard settings
The 551 Integrated Amplifier provides six alternative standard settings, called Types, which configure all aspects of the integrated amplifier into the six most commonly needed configurations.
Choosing one of the six standard settings overrides any other configuration you may have performed, and so can be used to reset the configuration of the integrated amplifier.
To select a standard setting
●Turn off the integrated amplifier, using the power switch on the back panel.
●Turn on the power again while holding down the Off key on the front panel.
By default, the integrated amplifier is supplied set to Type 1.
The display will show:
Type
amplifier
If you have a system containing only Meridian 500 Series units then you should choose one of Types 5, 1, 4, or 3. These give progressively larger numbers of inputs, as shown in the table
It will then show:
Ty 1
Customising the integrated
opposite.
If your system includes any Meridian 600 or 200 Series units you should choose Type 2 or Type 6. For more information see To connect to Meridian 600 or 200 Series equipment, page 30.
●Press V or A to change the type number.
For example, to select Type 3 | Ty 3 | |
the display shows: | ||
|
●Turn off the integrated amplifier using the power switch on the back panel.
●Turn on again to use the standard settings you have selected.
16
