Configuring the sources
When the integrated amplifier is set to one of the standard settings the twelve source selection keys on the remote select the standard labels and inputs, as shown in the table on page 17.
If the configuration you want is not catered for by one of the standard settings, you can configure each source individually.
To configure a source
●Turn off the integrated amplifier, using the power switch on the back panel.
●Turn on the power again while holding down the Display key on the front panel.
The display will show:
Conf
Customising the integrated amplifier
The 551 Integrated Amplifier provides 12 sources corresponding to the 12 source selection keys on the remote:
CD, Radio, LP, TV, Tape1, Tape2, CDR, Cable, Text, VCR1, VCR2, and LD.
For each source you can configure:
❍The label used for it on the front panel display, from 45 alternative labels.
❍The audio input it selects.
❍The comms type and address, to identify other Meridian 500 Series equipment.
The procedure for doing this is as follows.
●Press Source until the
For example, to configure the CD | CDCD | |
source the display initially shows: | ||
|
●Press Copy (front panel), or > and < (remote), to step between options.
The
The options are summarised in the table shown opposite.
18