Selecting a source
During normal use the integrated amplifier should be left in the | For example, if you select the | CD65 | ||
standby state. This uses a negligible amount of electricity, but | CD input the display will show: | |||
| ||||
ensures that the components of the integrated amplifier operate |
|
|
| |
at maximum efficiency from the moment you start. | By default, the following six sources are available: | |||
If you are not going to use the integrated amplifier for a period of | Source | Label | Input | |
several days you should switch the unit completely off, at the |
|
|
| |
CD | CD | A2 | ||
back panel, and disconnect it from the AC power supply. | ||||
|
|
| ||
| Radio | RD | A3 | |
To switch on from standby
●Press Source (front panel), or select a source by pressing the appropriate source key on the remote: eg CD.
If the 551 Integrated Amplifier is part of a Meridian system, it will automatically switch on any other unit in the system, such as the CD player.
To select a source
LP | LP | A1 |
TV | TV | A5 |
Tape1 | T1 | A4 |
Tape2 | T2 | A6 |
To switch to standby
●Press Off on the front panel or the remote.
Using the integrated
●Press Source (front panel) until the display shows the source you require, or press the appropriate source key on the remote: eg CD.
The display will show:
.
amplifier
The display shows the source, and volume setting.
If you have other Meridian 500 Series equipment connected to the integrated amplifier, these units will also switch to standby.
11
