Setting up the integrated amplifier
The following table gives details of the audio outputs:
Use this output | To connect to this |
Right/Left Output | Loudspeakers of 4Ω to 15Ω, using |
| either banana plug or bare wire |
| connections. |
An additional power amplifier or active | |
| loudspeakers. |
Tape Out | Tape recorder output. |
To connect to a tape recorder
●Connect the analogue output from the tape recorder to the Tape 1 input on the integrated amplifier (or another input if you prefer).
●Connect the Tape Out from the integrated amplifier to the analogue input on the tape recorder.
To connect to other Meridian 500 Series equipment
●Connect one of the COMMS sockets on the back panel of the integrated amplifier to one of the COMMS socket on another 500 Series unit, using the 500 comms lead.
The sequence in which you connect the units is not important.
COMMS | COMMS |
Then configure the units with the following automatic setup procedure:
●Switch all the units to standby.
●Press Clear on the remote.
Each unit will display: | Auto | |
| ||
|
| |
One unit will then be designated | Con | |
as the controller, and display: | ||
|
28
