
Using DSP5000 | 12 |
|
|
When you are sure that the DSP5000s are in the right places, you should adjust and finally tighten the feet with the wrench provided.
We strongly suggest that you try to use the spike feet, in order to get the best sound.
∙Foot caps may be fitted if the spikes are unacceptable
The spikes allow the DSP5000s to rest firmly on the floor. A spike passes through carpet to the wood or concrete below, and does less damage in the long run than a wide foot.
The best sound possible will only be obtained if the DSP5000s are firmly mounted and cannot rock at all. If the finish of the floor prevents the use of spikes, leave the plastic covers on, but adjust the feet to the floor so that the DSP5000s are vertical and show no tendency to rock.
One or two days after installation, check the tightness of the screws retaining the drivers. These screws may loosen during shipping or with extremes of temperature or humidity, and the speaker will not sound its best if they are loose. The screws should be checked every few months, particularly if the speakers are used to play loud music for long periods.
Tip Like all digital products, the DSP5000 emits some
Starting off with DSP5000
First install the DSP5000s, using the information in the Getting going sheet. When they have been used for a while, you may wish to change the setup in order to
Before turning on the power, check once again that you have made all the connections correctly and that you have not disturbed any existing connections in the process.
Switching onThe power switch is located directly next to the power inlet on the right- rear of DSP5000.
1.Switch on the power to the sources, but for now do not start them playing.
2.Turn on the power switch at the rear of the master DSP5000. A small point on the display should now be illuminated:
∙
3.Turn on the power switch at the rear of the slave DSP5000. A small point on the display should now be illuminated:
If there are no lightsCheck the integrity of your power connections, including any fuses in your supply. If the Standby point is still not illuminated and the rest of your system is functioning, contact your dealer for help.
DSP5000 User Guide