Help 52

obtain an up-to-date EPROM and fit it. Operating code can always be updated.

3.Make sure that the whole system is set up in either 200 mode or in 500 mode.

Note All Meridian products must be in the same mode. 200 or 600-Series products can only work in 200 mode and if you intend to incorporate these in a DSP5000 system, the speakers and any 500-Series components must be put into 200-mode (normally Type 2).

DSP5000s do not respond

The communications between MSR and speaker could be being interrupted by sunlight in the infra-red pickup behind the display.

DSP5000s go silent when used hard

DSP5000 has a temperature-sensing system on board that prevents overheating of the electronics by cutting out the sound. The sound will reset when they have cooled down.

When this system is activated, the display on the offending speaker will show

Hot

What have you been playing?

Communications not working between DSP5000 and other Meridian products

If you have this problem, check the connections carefully. The section starting on page 46 deals with this in some detail. Then check the following:

Are you using a B-lead or P-lead instead of a B1-lead?

Are you using a Q-lead instead of a Q1-lead?

Are you using an A-lead with a Meridian tuner? The A-Lead is not suitable for this; you should request a B1-Lead.

If you cannot see an obvious problem, connect the Comms one product at a time. If you cannot solve the difficulty refer to your dealer, but first note the software versions fitted in all of your Meridian items.

To find out the software version for a Meridian product:

1.Press its Display key while it is in Standby. (If it does not have a display key, use a 209 remote control or refer to the manual supplied with the product).

Note your connections carefully.

Note Make sure that the whole system is set up in either 200 mode or in 500 mode.

Note All Meridian products must be in the same mode. 200 or 600-Series products can only work in 200 mode and if you intend to incorporate these in a DSP5000 system, the speakers and any 500-Series components must be put into 200-mode (normally Type 2).

Radio interference

Note DSP5000 is designed to comply with all relevant international standards concerning local-oscillator re-radiation.

DSP5000 User Guide