Using DSP5000

16

 

 

1

Here 1 is the number of the track currently playing on the disc.

If the disc includes significant index points, the display will be like this:

3.4

3.4here means track 3, index point 4. In theory, with the right disc, we could see displays of track and index up to 99.99. Index point 1 is never displayed.

While the CD player is loading a disc (reading the disc’s directory), the

DSP5000 will show the directory message:

dir

At the end of a CD, the DSP5000 will detect the lead-out track and momentarily display the message

End

1.With the disc playing, press Display again. You will see a disc time display, counting up as the disc plays.

2.Press Display again. You now have a display of time for the current track only, also counting up as the disc plays.

3.Press Display again. The display should go blank on both master and slave.

4.Pressing Display again brings you back to the source and volume display.

One useful way to set up DSP5000s is to leave the track display on the master, since the slave always displays the source and volume.

If the CD player is in the same room, you can adjust its display to give you additional time information.

Try pressing Display until you are familiar with its operation.

Other information reviewed in Standby

1.Press and hold Display

The display will show the version number of the microcontroller software, followed by the currently-loaded DSP software. For example:

2.2

P1.81d1.2441b

Note The last DSP version number will depend on the operating mode of the DSP5000. The first two digits represent the sampling frequency; DSP5000 automatically reloads a new program for each sampling rate. The version numbers will also be different in Test and Calibrate.

Volume

To raise or lower the volume:

1. Press the upper or lower or red key

The volume level displayed should count up or down, and will range from 1 to 99. Each step is precisely 1dB.

DSP5000 User Guide