Connecting DSP5000

44

 

 

∙If a power-line filter is to be used, try to use a permanent type, and be sure that it is approved to the standards of your territory and that it retains the grounding

WARNING: DSP5000 must be grounded.

Connection using M5- and S5-leads

Many systems will require only the supplied composite M5- and S5-leads. If these are not appropriate, further information can be found in the section starting on page 46.

To get a CD player working with the DSP5000s, proceed as follows:

1.Locate the cable marked with ‘S5’. This is a DIN + Phono to DIN + Phono lead, about 6m long.

2.Connect one DIN plug to the Comms Input socket and the accompanying phono plug to the D1 socket on the slave DSP5000.

3.Connect the other end to the Comms Output socket and the D OUT socket of the master.

This completes the interconnection of the DSP5000 pair. Now:

4.Locate the cable marked with ‘M5’. This is a DIN + Phono to DIN + Phono lead, about 8m long.

5.Locate the end with the single DIN and phono plug. Connect this DIN plug to the Comms Input socket and the phono plug to the D1 socket on the master.

6.At the other end of this cable, locate the phono plug and connect it to the digital output of the CD player.

Note Getting this far should provide you with audio, and further connections will give you control of any Meridian products in your system. For connection of Meridian Comms, see page 46.

DSP5000 User Guide