Customising using Setup

42

 

 

Recalling settings in Setup

The Store key operates normally as a recall when there is no tone cursor displayed.

1.Wait for a volume, track or time display on the master

2.Press Store

Limitations of storing

Tilt and bass settings are stored by each source independently. Phase, axis and boundary settings are stored for all sources, and the last setting stored is that used for all sources.

Centre-channel options

Using the centre position control

To change the centre position setting:

1.Press the w or e menu key until the centre position display shows. The master display will momentarily show

C.P. 1

2.Press either the n or s menu key. Choose a setting 1–4 following the guidelines in the handbook for the Centre speaker.

Using the centre tilt-offset control

To change the centre tilt offset:

1.Press the w or e menu key until the centre tilt-offset display shows. The master display will momentarily show

C.t. 0

2.Press either the n or s menu key. Choose a setting following the guidelines in the handbook for the Centre speaker.

Note When customisation is complete, switch the power off, wait for 3 seconds, then switch it on again to restore normal operation and to save what you have done.

Connecting DSP5000

Four types of connection must be made to the DSP5000:

∙power (see page 12)

∙digital audio (see page 45)

∙communications (see page 46)

∙RS232 to a computer (see page 48)

You will need to plan the connections with the installation you wish to achieve in mind. It is best to do this while deciding where to put the DSP5000s, as this decision may affect the positioning of the rest of your system, and the way in which you connect it. The decision as to which speaker should be master is also dependent on both positioning and connections.

The following sections will explain in detail the options open to you. Remember that your Meridian dealer is chosen for his expertise in this area. If in doubt, you can always refer to him.

DSP5000 User Guide