Help 50

Help!

Standby point not lit

Check the following:

1.There is AC power connected to the socket on the rear of the DSP5000

2.The power switch on the rear panel of the DSP5000 is turned on

If the DSP5000 still will not light up, check any fuses in your power supply and the fuse in the DSP5000. If these are all intact, contact your dealer.

No sound

1.Check the AC power supply to DSP5000. If the power is on, you should be able to see the Standby display in the window:

∙

2.Check the AC supply to the other units in the system

3.Check that the correct source has been selected, and that this source is running and producing music

4.Check that all interconnections have been made to the correct sockets

5.Check that the DSP5000 is not in Mute. If it is, you will see this display:

Att.

6.Check that the volume is set sufficiently high for audibility (say at 50)

7.If there is still no sound, reset the DSP5000 by switching the power off, waiting for 30 seconds, then switching it back on

Sound from one channel only

1.Check interconnect and speaker wiring

2.Do both displays say the same thing?

Channels reversed

Remember that for digital inputs left or right is determined at setup; see the sections on pages 33 and 34. Default conditions set the master to left.

1. If necessary re-configure; see page 34

Settings lost

1.Check the procedures set out in the section following page 30

2.Check EPROM version is 2.2 or higher, see page 16.

3.Contact your dealer

Hum

Hum is normally only to be expected with analogue sources. Check the grounding of the analogue preamplifier. See the handbook supplied with your preamplifier for help.

Clicks with digital sources

If clicks appear in the sound when the system is switched to a digital source, the two most likely reasons are as follows:

1.If clicks only occur when the source is running (playing), the problem is due to error correction or transmission failure. First check the condition of the disc or tape. If the player is a Meridian 207, 208 or 602, look for a flashing Error light. Check the integrity of the connections between the digital audio source and the DSP5000. Are you using good 75-ohm cable?

DSP5000 User Guide