Customising using Config

34

 

 

Inside Config you can move between them at will. To go to

1.root: press Clear

2.system: press Off

3.source: press a source key – e.g. CD

Note In Config, the speaker is silenced.

How to use Config

1.Switch off the master DSP5000, using the power switch on the back, and wait for 3 seconds

2.While pressing the 0 key on the remote control, switch the power on again. The display will indicate the root menu that shows the left/right and master/slave settings; for example,

r.

indicates a right master.

3. Release the 0 key

Root menu options

The root menu controls the overall operation of the DSP5000s, with options for master/slave and left/right.

You get to the root menu by

1.Selecting Config, as above

or, at any stage in the Config programming process,

1. Pressing Clear or Off

Choosing left or right

To change a left speaker into a right speaker, or vice versa:

1. Press n or s on the remote control

Note If you have started with Type 6 or selected ‘CEn.Y’ elsewhere in Config, then you also have the choices ‘C’ and ‘S’ for Centre and Subwoofer. If you want the speaker to be a Centre in a 565-based system, choose ‘C’.1

Choosing master or slave

To change a master to a slave, or back again:

1.Press Play on the remote control

r. S.

This display indicates a right slave.

System menu

To get into the system menu:

1. Press the menu e key

Preamplifier options

The first digit in the system menu identifies the dominant preamplifier in the system.

1This choice also permits you to make the DSP5000 the system subwoofer. This choice would normally be made only for diagnosis!

DSP5000 User Guide